sworcester – Activité – Prusa3D Forum

Notifications

Clear all

sworcester

Groupe: Enregistré

A(ont) rejoint: 2017/02/03

Eminent Member

	Slow down the infill speed a little bit works well for me. ... Dans le forum Others (Archive)	il y a 8 years
	I am printing and testing different infill patterns and came... Dans le forum Others (Archive)	il y a 8 years
	PETG and renticular fill Dans le forum Others (Archive)	il y a 8 years
	What is the number? Some tension, frequency? (My book only h... Dans le forum Others (Archive)	il y a 8 years
	I made the mistake of starting an 11 hour print BEFORE upgra... Dans le forum Others (Archive)	il y a 8 years
	My guess would be that the retraction settings are inaccurat... Dans le forum Others (Archive)	il y a 8 years
	With RC5, I did not have infill problems with 15% honeycomb ... Dans le forum Others (Archive)	il y a 8 years
	My guess would be that the retraction settings are inaccurat... Dans le forum Others (Archive)	il y a 8 years
	Are you running the same speeds as RC4? RC5 disabled Linear ... Dans le forum Others (Archive)	il y a 8 years
	New firmware print issues with Infill Dans le forum Others (Archive)	il y a 8 years
	Im using a hardend steel nozzle from E3D, i cannot see any d... Dans le forum Others (Archive)	il y a 8 years
	also have to be careful how much you tighten it. They su... Dans le forum Others (Archive)	il y a 8 years
	320 mm. That, I had to look at my Misumi order PSFJ8-320/330... Dans le forum Others (Archive)	il y a 8 years
	I was able to print PETG without any problem until the FW/SW... Dans le forum Others (Archive)	il y a 8 years
	That is how it fit when I put the hot end in on my parts as ... Dans le forum Others (Archive)	il y a 8 years
	It has gotten a little better in the latest firmware, but be... Dans le forum Others (Archive)	il y a 8 years
	There is another thread on this, but essentially Update the... Dans le forum Others (Archive)	il y a 8 years
	I figured out that turning on the auto load filament, remove... Dans le forum Others (Archive)	il y a 8 years
	Possible workaround until this is fixed: Is there a "Move ex... Dans le forum Others (Archive)	il y a 8 years

Page 2 / 3 Précédent Suivant

Statistiques du forum

585 Forums

68.2 K Sujets

477.9 K Messages

10 En-ligne

75.9 K Membres

Le dernier des messages: The Cryogrip Pro Glacier plate is an excellent cheaper alternative to the Satin plate with one minor caveat on the Core One Notre nouveau membre: ArtiVIVO Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé