sworcester – Aktivität

Benachrichtigungen

Alles löschen

sworcester

Gruppe: Registriert

Beigetreten: 2017/02/03

Eminent Member

	Slow down the infill speed a little bit works well for me. ... Im Forum Others (Archive)	Vor 8 years
	I am printing and testing different infill patterns and came... Im Forum Others (Archive)	Vor 8 years
	PETG and renticular fill Im Forum Others (Archive)	Vor 8 years
	What is the number? Some tension, frequency? (My book only h... Im Forum Others (Archive)	Vor 8 years
	I made the mistake of starting an 11 hour print BEFORE upgra... Im Forum Others (Archive)	Vor 8 years
	My guess would be that the retraction settings are inaccurat... Im Forum Others (Archive)	Vor 8 years
	With RC5, I did not have infill problems with 15% honeycomb ... Im Forum Others (Archive)	Vor 8 years
	My guess would be that the retraction settings are inaccurat... Im Forum Others (Archive)	Vor 8 years
	Are you running the same speeds as RC4? RC5 disabled Linear ... Im Forum Others (Archive)	Vor 8 years
	New firmware print issues with Infill Im Forum Others (Archive)	Vor 8 years
	Im using a hardend steel nozzle from E3D, i cannot see any d... Im Forum Others (Archive)	Vor 8 years
	also have to be careful how much you tighten it. They su... Im Forum Others (Archive)	Vor 8 years
	320 mm. That, I had to look at my Misumi order PSFJ8-320/330... Im Forum Others (Archive)	Vor 8 years
	I was able to print PETG without any problem until the FW/SW... Im Forum Others (Archive)	Vor 8 years
	That is how it fit when I put the hot end in on my parts as ... Im Forum Others (Archive)	Vor 8 years
	It has gotten a little better in the latest firmware, but be... Im Forum Others (Archive)	Vor 8 years
	There is another thread on this, but essentially Update the... Im Forum Others (Archive)	Vor 8 years
	I figured out that turning on the auto load filament, remove... Im Forum Others (Archive)	Vor 8 years
	Possible workaround until this is fixed: Is there a "Move ex... Im Forum Others (Archive)	Vor 8 years

Seite 2 / 3 Vorherige Nächstes

Forums-Statistiken

585 Foren

68.2 K Themen

477.6 K Beiträge

12 Online

75.9 K Mitglieder

Letzter Beitrag: Belt Tensioners "Frozen" Unser neuestes Mitglied: mnentwig Neueste Beiträge Ungelesene Beiträge Schlagwörter

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen