Prusa3D Forum

Notifications

Clear all

sworcester

Skupina: Registrovaný

Přidal se: 2017/02/03

Eminent Member

	what about the tension? When it's printing, can you just pul... In forum How do I print this? (Printing help)	před 4 months
	Ninjatek Edge on my MK4 with .4 nozzle. Trying to track down... In forum How do I print this? (Printing help)	před 4 months
	At what point does it again check tension? Seems that if I ... In forum Assembly and first prints troubleshooting	před 6 years
	I slowed infill down the 45mm/s and that resolved the issue.... In forum Others (Archive)	před 7 years
	Slow down the infill speed a little bit works well for me. ... In forum Others (Archive)	před 7 years
	I am printing and testing different infill patterns and came... In forum Others (Archive)	před 7 years
	PETG and renticular fill In forum Others (Archive)	před 7 years
	What is the number? Some tension, frequency? (My book only h... In forum Others (Archive)	před 7 years
	I made the mistake of starting an 11 hour print BEFORE upgra... In forum Others (Archive)	před 7 years
	My guess would be that the retraction settings are inaccurat... In forum Others (Archive)	před 7 years
	With RC5, I did not have infill problems with 15% honeycomb ... In forum Others (Archive)	před 7 years
	My guess would be that the retraction settings are inaccurat... In forum Others (Archive)	před 7 years
	Are you running the same speeds as RC4? RC5 disabled Linear ... In forum Others (Archive)	před 7 years
	New firmware print issues with Infill In forum Others (Archive)	před 7 years
	Im using a hardend steel nozzle from E3D, i cannot see any d... In forum Others (Archive)	před 7 years
	also have to be careful how much you tighten it. They su... In forum Others (Archive)	před 7 years
	320 mm. That, I had to look at my Misumi order PSFJ8-320/330... In forum Others (Archive)	před 7 years
	I was able to print PETG without any problem until the FW/SW... In forum Others (Archive)	před 7 years
	That is how it fit when I put the hot end in on my parts as ... In forum Others (Archive)	před 7 years

Stránka 1 / 2 Další

Fórum Statistiky

559 Fóra

63 K Témata

443.2 K Příspěvky

33 Online

67.8 K Uživatelé

Poslední Příspěvek: Prusa Core One - Intial thoughts...... Nový Uživatel: pinklemonade Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed