Prusa3D Forum

Notifications

Clear all

Slumb3rjack

Grupa: Zarejestrowany

Dołączył: 2020/05/11

Active Member

	I did find this post that was a bit enlightening. It basica... In forum How do I print this? (Printing help)	4 years temu
	Tried just manually entering G1 Z210; raise z And it sliced ... In forum How do I print this? (Printing help)	4 years temu
	Well I opened the sliced file in my C++ IDE just so I could ... In forum How do I print this? (Printing help)	4 years temu
	(Sorry about the three posts, I didn't make the time limit f... In forum How do I print this? (Printing help)	4 years temu
	So I watched Pronterface closely this time, and when the pri... In forum How do I print this? (Printing help)	4 years temu
	Looks like it worked. I still had some sagging on the top o... In forum How do I print this? (Printing help)	4 years temu
	End gcode not fully executing In forum How do I print this? (Printing help)	4 years temu
	Ok guys, I will give it a try in that orientation and report... In forum How do I print this? (Printing help)	4 years temu
	@cwbullet True, but I tend to stick to the same two brands, ... In forum General discussion, announcements and releases	4 years temu
	Hi Szumi, I print almost exclusively PETG (eSUN and Prusamen... In forum General discussion, announcements and releases	4 years temu
	Proper Orientation? In forum How do I print this? (Printing help)	4 years temu

Statystyki Forum

565 Fora

63.8 K Tematy

447.5 K Posty

19 Online

69.4 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte