Prusa3D Forum

Notifications

Clear all

Slumb3rjack

Skupina: Registrovaný

Přidal se: 2020/05/11

Active Member

	I did find this post that was a bit enlightening. It basica... In forum How do I print this? (Printing help)	před 4 years
	Tried just manually entering G1 Z210; raise z And it sliced ... In forum How do I print this? (Printing help)	před 4 years
	Well I opened the sliced file in my C++ IDE just so I could ... In forum How do I print this? (Printing help)	před 4 years
	(Sorry about the three posts, I didn't make the time limit f... In forum How do I print this? (Printing help)	před 4 years
	So I watched Pronterface closely this time, and when the pri... In forum How do I print this? (Printing help)	před 4 years
	Looks like it worked. I still had some sagging on the top o... In forum How do I print this? (Printing help)	před 4 years
	End gcode not fully executing In forum How do I print this? (Printing help)	před 4 years
	Ok guys, I will give it a try in that orientation and report... In forum How do I print this? (Printing help)	před 4 years
	@cwbullet True, but I tend to stick to the same two brands, ... In forum General discussion, announcements and releases	před 4 years
	Hi Szumi, I print almost exclusively PETG (eSUN and Prusamen... In forum General discussion, announcements and releases	před 4 years
	Proper Orientation? In forum How do I print this? (Printing help)	před 4 years

Fórum Statistiky

565 Fóra

63.8 K Témata

447.5 K Příspěvky

23 Online

69.4 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed