Prusa3D Forum

Benachrichtigungen

Alles löschen

Slumb3rjack

Gruppe: Registriert

Beigetreten: 2020/05/11

Active Member

	I did find this post that was a bit enlightening. It basica... Im Forum How do I print this? (Printing help)	Vor 4 years
	Tried just manually entering G1 Z210; raise z And it sliced ... Im Forum How do I print this? (Printing help)	Vor 4 years
	Well I opened the sliced file in my C++ IDE just so I could ... Im Forum How do I print this? (Printing help)	Vor 4 years
	(Sorry about the three posts, I didn't make the time limit f... Im Forum How do I print this? (Printing help)	Vor 4 years
	So I watched Pronterface closely this time, and when the pri... Im Forum How do I print this? (Printing help)	Vor 4 years
	Looks like it worked. I still had some sagging on the top o... Im Forum How do I print this? (Printing help)	Vor 4 years
	End gcode not fully executing Im Forum How do I print this? (Printing help)	Vor 4 years
	Ok guys, I will give it a try in that orientation and report... Im Forum How do I print this? (Printing help)	Vor 4 years
	@cwbullet True, but I tend to stick to the same two brands, ... Im Forum General discussion, announcements and releases	Vor 4 years
	Hi Szumi, I print almost exclusively PETG (eSUN and Prusamen... Im Forum General discussion, announcements and releases	Vor 4 years
	Proper Orientation? Im Forum How do I print this? (Printing help)	Vor 4 years

Forums-Statistiken

565 Foren

63.8 K Themen

447.5 K Beiträge

19 Online

69.5 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen