Prusa3D Forum

Notifiche

Cancella tutti

Slumb3rjack

Gruppo: Registrato

Registrato: 2020/05/11

Active Member

	I did find this post that was a bit enlightening. It basica... Nel forum How do I print this? (Printing help)	4 years fa
	Tried just manually entering G1 Z210; raise z And it sliced ... Nel forum How do I print this? (Printing help)	4 years fa
	Well I opened the sliced file in my C++ IDE just so I could ... Nel forum How do I print this? (Printing help)	4 years fa
	(Sorry about the three posts, I didn't make the time limit f... Nel forum How do I print this? (Printing help)	4 years fa
	So I watched Pronterface closely this time, and when the pri... Nel forum How do I print this? (Printing help)	4 years fa
	Looks like it worked. I still had some sagging on the top o... Nel forum How do I print this? (Printing help)	4 years fa
	End gcode not fully executing Nel forum How do I print this? (Printing help)	4 years fa
	Ok guys, I will give it a try in that orientation and report... Nel forum How do I print this? (Printing help)	4 years fa
	@cwbullet True, but I tend to stick to the same two brands, ... Nel forum General discussion, announcements and releases	4 years fa
	Hi Szumi, I print almost exclusively PETG (eSUN and Prusamen... Nel forum General discussion, announcements and releases	4 years fa
	Proper Orientation? Nel forum How do I print this? (Printing help)	4 years fa

Statistiche Forum

565 Forum

63.8 K Discussioni

447.5 K Post

21 Online

69.4 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso