Prusa3D Forum

Notifications

Clear all

Slumb3rjack

Groupe: Enregistré

A(ont) rejoint: 2020/05/11

Active Member

	I did find this post that was a bit enlightening. It basica... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Tried just manually entering G1 Z210; raise z And it sliced ... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Well I opened the sliced file in my C++ IDE just so I could ... Dans le forum How do I print this? (Printing help)	il y a 4 years
	(Sorry about the three posts, I didn't make the time limit f... Dans le forum How do I print this? (Printing help)	il y a 4 years
	So I watched Pronterface closely this time, and when the pri... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Looks like it worked. I still had some sagging on the top o... Dans le forum How do I print this? (Printing help)	il y a 4 years
	End gcode not fully executing Dans le forum How do I print this? (Printing help)	il y a 4 years
	Ok guys, I will give it a try in that orientation and report... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@cwbullet True, but I tend to stick to the same two brands, ... Dans le forum General discussion, announcements and releases	il y a 4 years
	Hi Szumi, I print almost exclusively PETG (eSUN and Prusamen... Dans le forum General discussion, announcements and releases	il y a 4 years
	Proper Orientation? Dans le forum How do I print this? (Printing help)	il y a 4 years

Statistiques du forum

565 Forums

63.8 K Sujets

447.5 K Messages

21 En-ligne

69.5 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé