|
Random: Any reason this is still stickied to the top of the ... In forum PrusaSlicer |
12 months ago |
|
Random question about how slicer generates supports In forum PrusaSlicer |
12 months ago |
|
Same issue here. It works every now and then, and if I look ... In forum Bugs & Errors |
12 months ago |
|
I can try drying again. Mine is about a 2 months old. Ordere... In forum How do I print this? (Printing help) |
2 years ago |
|
That is why I have been too scared to try it on my PEI sheet... In forum How do I print this? (Printing help) |
2 years ago |
|
I saw 17/04.. didn't see the year. Thanks for the quick resp... In forum How do I print this? (Printing help) |
2 years ago |
|
I have the same problem. Satin sheet. Textured sheet, dried ... In forum How do I print this? (Printing help) |
2 years ago |
|
And correct you are! I had download the newer version this m... In forum PrusaSlicer |
2 years ago |
|
OK.. so that then DOES make sense, and I'm a lot less confus... In forum PrusaSlicer |
2 years ago |
|
[Confused] PrusaSlicer says model is to big In forum PrusaSlicer |
2 years ago |
|
Thanks all.Took 12.5 hours to assemble (I was streaming it a... In forum General discussion, announcements and releases |
3 years ago |
|
Thanks @diem and @Bob. I did a bit of research a few years a... In forum General discussion, announcements and releases |
3 years ago |
|
Newbie filament recommendations In forum General discussion, announcements and releases |
3 years ago |
