Prusa3D Forum

Notifications

Clear all

Robert

Grupa: Zarejestrowany

Dołączył: 2016/11/21

Active Member

	I really thought my just-completed MK4 was broken - it just ... In forum Hardware, firmware and software help	12 months temu
	I printed these last night and started using them on my just... In forum Others (Archive)	7 years temu
	I think it's interesting to watch the extruder move the fila... In forum Others (Archive)	7 years temu
	I also find the Prusa-design (spool edge on shaft) to not sp... In forum Others (Archive)	7 years temu
	Appreciated, Aaron. I'll re-check the Rambo interior. I'm ... In forum Others (Archive)	7 years temu
	I'm not sure I understand the desire to have PTFE from the s... In forum Others (Archive)	7 years temu
	The very first model I ran after the MM upgrade was the 4-co... In forum Others (Archive)	7 years temu
	Thanks for the reply, Aaron. I found that list referenced i... In forum Others (Archive)	7 years temu
	Layer shift in both X and Y after MM upgrade In forum Others (Archive)	7 years temu
	For a quick fix, just slice 13mm off of each of the four PTF... In forum Others (Archive)	7 years temu
	Try printing a little slower and give the perimeter filament... In forum Prusa i3 kit (Archive)	8 years temu

Statystyki Forum

565 Fora

63.6 K Tematy

446.2 K Posty

20 Online

68.9 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte