Prusa3D Forum

Notifications

Clear all

Robert

Skupina: Registrovaný

Přidal se: 2016/11/21

Active Member

	I really thought my just-completed MK4 was broken - it just ... In forum Hardware, firmware and software help	před 12 months
	I printed these last night and started using them on my just... In forum Others (Archive)	před 7 years
	I think it's interesting to watch the extruder move the fila... In forum Others (Archive)	před 7 years
	I also find the Prusa-design (spool edge on shaft) to not sp... In forum Others (Archive)	před 7 years
	Appreciated, Aaron. I'll re-check the Rambo interior. I'm ... In forum Others (Archive)	před 7 years
	I'm not sure I understand the desire to have PTFE from the s... In forum Others (Archive)	před 7 years
	The very first model I ran after the MM upgrade was the 4-co... In forum Others (Archive)	před 7 years
	Thanks for the reply, Aaron. I found that list referenced i... In forum Others (Archive)	před 7 years
	Layer shift in both X and Y after MM upgrade In forum Others (Archive)	před 7 years
	For a quick fix, just slice 13mm off of each of the four PTF... In forum Others (Archive)	před 7 years
	Try printing a little slower and give the perimeter filament... In forum Prusa i3 kit (Archive)	před 8 years

Fórum Statistiky

565 Fóra

63.6 K Témata

446.2 K Příspěvky

24 Online

68.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed