Prusa3D Forum

Notifications

Clear all

Robert

Groupe: Enregistré

A(ont) rejoint: 2016/11/21

Active Member

	I really thought my just-completed MK4 was broken - it just ... Dans le forum Hardware, firmware and software help	il y a 12 months
	I printed these last night and started using them on my just... Dans le forum Others (Archive)	il y a 7 years
	I think it's interesting to watch the extruder move the fila... Dans le forum Others (Archive)	il y a 7 years
	I also find the Prusa-design (spool edge on shaft) to not sp... Dans le forum Others (Archive)	il y a 7 years
	Appreciated, Aaron. I'll re-check the Rambo interior. I'm ... Dans le forum Others (Archive)	il y a 7 years
	I'm not sure I understand the desire to have PTFE from the s... Dans le forum Others (Archive)	il y a 7 years
	The very first model I ran after the MM upgrade was the 4-co... Dans le forum Others (Archive)	il y a 7 years
	Thanks for the reply, Aaron. I found that list referenced i... Dans le forum Others (Archive)	il y a 7 years
	Layer shift in both X and Y after MM upgrade Dans le forum Others (Archive)	il y a 7 years
	For a quick fix, just slice 13mm off of each of the four PTF... Dans le forum Others (Archive)	il y a 7 years
	Try printing a little slower and give the perimeter filament... Dans le forum Prusa i3 kit (Archive)	il y a 8 years

Statistiques du forum

565 Forums

63.6 K Sujets

446.2 K Messages

18 En-ligne

68.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé