Prusa3D Forum

Notifiche

Cancella tutti

Robert

Gruppo: Registrato

Registrato: 2016/11/21

Active Member

	I really thought my just-completed MK4 was broken - it just ... Nel forum Hardware, firmware and software help	12 months fa
	I printed these last night and started using them on my just... Nel forum Others (Archive)	7 years fa
	I think it's interesting to watch the extruder move the fila... Nel forum Others (Archive)	7 years fa
	I also find the Prusa-design (spool edge on shaft) to not sp... Nel forum Others (Archive)	7 years fa
	Appreciated, Aaron. I'll re-check the Rambo interior. I'm ... Nel forum Others (Archive)	7 years fa
	I'm not sure I understand the desire to have PTFE from the s... Nel forum Others (Archive)	7 years fa
	The very first model I ran after the MM upgrade was the 4-co... Nel forum Others (Archive)	7 years fa
	Thanks for the reply, Aaron. I found that list referenced i... Nel forum Others (Archive)	7 years fa
	Layer shift in both X and Y after MM upgrade Nel forum Others (Archive)	7 years fa
	For a quick fix, just slice 13mm off of each of the four PTF... Nel forum Others (Archive)	7 years fa
	Try printing a little slower and give the perimeter filament... Nel forum Prusa i3 kit (Archive)	8 years fa

Statistiche Forum

565 Forum

63.6 K Discussioni

446.2 K Post

20 Online

68.9 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso