Prusa3D Forum

Benachrichtigungen

Alles löschen

Robert

Gruppe: Registriert

Beigetreten: 2016/11/21

Active Member

	I really thought my just-completed MK4 was broken - it just ... Im Forum Hardware, firmware and software help	Vor 12 months
	I printed these last night and started using them on my just... Im Forum Others (Archive)	Vor 7 years
	I think it's interesting to watch the extruder move the fila... Im Forum Others (Archive)	Vor 7 years
	I also find the Prusa-design (spool edge on shaft) to not sp... Im Forum Others (Archive)	Vor 7 years
	Appreciated, Aaron. I'll re-check the Rambo interior. I'm ... Im Forum Others (Archive)	Vor 7 years
	I'm not sure I understand the desire to have PTFE from the s... Im Forum Others (Archive)	Vor 7 years
	The very first model I ran after the MM upgrade was the 4-co... Im Forum Others (Archive)	Vor 7 years
	Thanks for the reply, Aaron. I found that list referenced i... Im Forum Others (Archive)	Vor 7 years
	Layer shift in both X and Y after MM upgrade Im Forum Others (Archive)	Vor 7 years
	For a quick fix, just slice 13mm off of each of the four PTF... Im Forum Others (Archive)	Vor 7 years
	Try printing a little slower and give the perimeter filament... Im Forum Prusa i3 kit (Archive)	Vor 8 years

Forums-Statistiken

565 Foren

63.6 K Themen

446.2 K Beiträge

19 Online

68.9 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen