Prusa3D Forum

Notifications

Clear all

Ragedude

Grupa: Zarejestrowany

Dołączył: 2022/01/12

Active Member

	The idler was too weak and probably out of PLA which softene... In forum Hardware, firmware and software help	1 year temu
	jup, upgraded Idler made from abs works so far (found it on ... In forum Hardware, firmware and software help	1 year temu
	Prusa XL hotend clogged due to wrong temparture measuring? In forum Hardware, firmware and software help	1 year temu
	1. there is a needle included intended just for that use, at... In forum Hardware, firmware and software help	1 year temu
	Ok, solved it, a friend told me i installed the wrong Softwa... In forum Hardware, firmware and software help	3 years temu
	Printer Bricked after Flashing? In forum Hardware, firmware and software help	3 years temu
	Hey, i got the same issue, it looks like the connector on th... In forum Hardware, firmware and software help	3 years temu

Statystyki Forum

565 Fora

63.6 K Tematy

446.2 K Posty

21 Online

69 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte