Avisos
Vaciar todo
Ragedude
Grupo: Registrado
Registrado: 2022/01/12
Active Member
1
|
The idler was too weak and probably out of PLA which softene... En el foro Hardware, firmware and software help |
hace 2 years | |
|
jup, upgraded Idler made from abs works so far (found it on ... En el foro Hardware, firmware and software help |
hace 2 years | |
|
Prusa XL hotend clogged due to wrong temparture measuring? En el foro Hardware, firmware and software help |
hace 2 years | |
|
1. there is a needle included intended just for that use, at... En el foro Hardware, firmware and software help |
hace 2 years | |
|
Ok, solved it, a friend told me i installed the wrong Softwa... En el foro Hardware, firmware and software help |
hace 4 years | |
|
Printer Bricked after Flashing? En el foro Hardware, firmware and software help |
hace 4 years | |
|
Hey, i got the same issue, it looks like the connector on th... En el foro Hardware, firmware and software help |
hace 4 years |