Prusa3D Forum

Notifications

Clear all

Ragedude

Skupina: Registrovaný

Přidal se: 2022/01/12

Active Member

	The idler was too weak and probably out of PLA which softene... In forum Hardware, firmware and software help	před 1 year
	jup, upgraded Idler made from abs works so far (found it on ... In forum Hardware, firmware and software help	před 1 year
	Prusa XL hotend clogged due to wrong temparture measuring? In forum Hardware, firmware and software help	před 1 year
	1. there is a needle included intended just for that use, at... In forum Hardware, firmware and software help	před 1 year
	Ok, solved it, a friend told me i installed the wrong Softwa... In forum Hardware, firmware and software help	před 3 years
	Printer Bricked after Flashing? In forum Hardware, firmware and software help	před 3 years
	Hey, i got the same issue, it looks like the connector on th... In forum Hardware, firmware and software help	před 3 years

Fórum Statistiky

565 Fóra

63.6 K Témata

446.2 K Příspěvky

20 Online

69 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed