Prusa3D Forum

Notifiche

Cancella tutti

Ragedude

Gruppo: Registrato

Registrato: 2022/01/12

Active Member

	The idler was too weak and probably out of PLA which softene... Nel forum Hardware, firmware and software help	1 year fa
	jup, upgraded Idler made from abs works so far (found it on ... Nel forum Hardware, firmware and software help	1 year fa
	Prusa XL hotend clogged due to wrong temparture measuring? Nel forum Hardware, firmware and software help	1 year fa
	1. there is a needle included intended just for that use, at... Nel forum Hardware, firmware and software help	1 year fa
	Ok, solved it, a friend told me i installed the wrong Softwa... Nel forum Hardware, firmware and software help	3 years fa
	Printer Bricked after Flashing? Nel forum Hardware, firmware and software help	3 years fa
	Hey, i got the same issue, it looks like the connector on th... Nel forum Hardware, firmware and software help	3 years fa

Statistiche Forum

565 Forum

63.6 K Discussioni

446.2 K Post

21 Online

69 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso