Prusa3D Forum

Notifications

Clear all

Ragedude

Group: Registered

Joined: 2022/01/12

Active Member

	The idler was too weak and probably out of PLA which softene... In forum Hardware, firmware and software help	12 months ago
	jup, upgraded Idler made from abs works so far (found it on ... In forum Hardware, firmware and software help	12 months ago
	Prusa XL hotend clogged due to wrong temparture measuring? In forum Hardware, firmware and software help	12 months ago
	1. there is a needle included intended just for that use, at... In forum Hardware, firmware and software help	12 months ago
	Ok, solved it, a friend told me i installed the wrong Softwa... In forum Hardware, firmware and software help	3 years ago
	Printer Bricked after Flashing? In forum Hardware, firmware and software help	3 years ago
	Hey, i got the same issue, it looks like the connector on th... In forum Hardware, firmware and software help	3 years ago

Forum Statistics

559 Forums

62.8 K Topics

442.4 K Posts

18 Online

67.4 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed