Notifiche
Cancella tutti
r2b
Gruppo: Registrato
Registrato: 2021/08/04
Active Member
1
|
The problem has nothing to do with the placement of the inne... Nel forum PrusaSlicer |
4 years fa | |
|
The seam being placed in different locations on the inner an... Nel forum PrusaSlicer |
4 years fa | |
| There's very little in the same market segment. There are, m... | 4 years fa | |
|
Even if you can calibrate or tune to minimise negative effec... Nel forum PrusaSlicer |
4 years fa | |
| I wish there were more competitors. I've had issues with the... | 4 years fa | |
|
Might be cheaper from here ($0.237 each + $10 DHL to USA)/p>... Nel forum Hardware, firmware and software help |
4 years fa | |
|
To clarify, have you printed with PLA without problems since... Nel forum Hardware, firmware and software help |
4 years fa | |
|
If it was the TSP algo then this behaviour should happen con... Nel forum PrusaSlicer |
4 years fa | |
|
Printing same section consecutively on two layers, defeating... Nel forum PrusaSlicer |
4 years fa |