Avisos
Vaciar todo
r2b
Grupo: Registrado
Registrado: 2021/08/04
Active Member
1
|
The problem has nothing to do with the placement of the inne... En el foro PrusaSlicer |
hace 4 years | |
|
The seam being placed in different locations on the inner an... En el foro PrusaSlicer |
hace 4 years | |
| There's very little in the same market segment. There are, m... | hace 4 years | |
|
Even if you can calibrate or tune to minimise negative effec... En el foro PrusaSlicer |
hace 4 years | |
| I wish there were more competitors. I've had issues with the... | hace 4 years | |
|
Might be cheaper from here ($0.237 each + $10 DHL to USA)/p>... En el foro Hardware, firmware and software help |
hace 4 years | |
|
To clarify, have you printed with PLA without problems since... En el foro Hardware, firmware and software help |
hace 4 years | |
|
If it was the TSP algo then this behaviour should happen con... En el foro PrusaSlicer |
hace 4 years | |
|
Printing same section consecutively on two layers, defeating... En el foro PrusaSlicer |
hace 4 years |