Prusa3D Forum

Notifications

Clear all

r2b

Groupe: Enregistré

A(ont) rejoint: 2021/08/04

Active Member

	The problem has nothing to do with the placement of the inne... Dans le forum PrusaSlicer	il y a 3 years
	The seam being placed in different locations on the inner an... Dans le forum PrusaSlicer	il y a 3 years
	There's very little in the same market segment. There are, m... Dans le forum General discussion, announcements and releases	il y a 3 years
	Even if you can calibrate or tune to minimise negative effec... Dans le forum PrusaSlicer	il y a 3 years
	I wish there were more competitors. I've had issues with the... Dans le forum General discussion, announcements and releases	il y a 3 years
	Might be cheaper from here ($0.237 each + $10 DHL to USA)/p>... Dans le forum Hardware, firmware and software help	il y a 3 years
	To clarify, have you printed with PLA without problems since... Dans le forum Hardware, firmware and software help	il y a 3 years
	If it was the TSP algo then this behaviour should happen con... Dans le forum PrusaSlicer	il y a 3 years
	Printing same section consecutively on two layers, defeating... Dans le forum PrusaSlicer	il y a 3 years

Statistiques du forum

565 Forums

63.9 K Sujets

447.7 K Messages

19 En-ligne

69.5 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé