Benachrichtigungen
Alles löschen
r2b
Gruppe: Registriert
Beigetreten: 2021/08/04
Active Member
1
|
The problem has nothing to do with the placement of the inne... Im Forum PrusaSlicer |
Vor 4 years | |
|
The seam being placed in different locations on the inner an... Im Forum PrusaSlicer |
Vor 4 years | |
| There's very little in the same market segment. There are, m... | Vor 4 years | |
|
Even if you can calibrate or tune to minimise negative effec... Im Forum PrusaSlicer |
Vor 4 years | |
| I wish there were more competitors. I've had issues with the... | Vor 4 years | |
|
Might be cheaper from here ($0.237 each + $10 DHL to USA)/p>... Im Forum Hardware, firmware and software help |
Vor 4 years | |
|
To clarify, have you printed with PLA without problems since... Im Forum Hardware, firmware and software help |
Vor 4 years | |
|
If it was the TSP algo then this behaviour should happen con... Im Forum PrusaSlicer |
Vor 4 years | |
|
Printing same section consecutively on two layers, defeating... Im Forum PrusaSlicer |
Vor 4 years |