PrusaTester2020 – Aktivita

Notifications

Clear all

PrusaTester2020

Skupina: Registrovaný

Přidal se: 2020/08/31

Estimable Member

	It looked like before the nozzle the filament was held or re... In forum PrusaSlicer	před 4 years
	Hi! Finally managed to completely fix the problem by putting... In forum PrusaSlicer	před 4 years
	Investigation continues. This is a picture from my last prin... In forum PrusaSlicer	před 4 years
	Did all that. Prove me I am wrong but if X and/or Y axis wer... In forum PrusaSlicer	před 4 years
	@tim-m30 The temperatures of the nozzle during the "bad" zon... In forum PrusaSlicer	před 4 years
	I adjusted the belt tension just before the frog print. They... In forum PrusaSlicer	před 4 years
	Sorry but the problem appeared today. It seemed it's not onl... In forum PrusaSlicer	před 4 years
	FIXED: The solution for this strange problem is in this post... In forum Hardware, firmware and software help	před 4 years
	@tim-m30 I tried with 2mm. wall and it was exactly 2mm (chec... In forum PrusaSlicer	před 4 years
	Hi! I think I managed to find what causes all my problems. O... In forum PrusaSlicer	před 4 years
	Yes, I also think that the nozzle with the fillament is pres... In forum PrusaSlicer	před 4 years
	I tried printing using this recommended settings:- lower ret... In forum PrusaSlicer	před 4 years
	Would you send me your config or it's confidential? In forum PrusaSlicer	před 4 years
	Here is the PrusaSlicer 3MK file attached. Attachment remo... In forum Hardware, firmware and software help	před 4 years
	Here is the PrusaSlicer 3MK file attached. Attachment remo... In forum PrusaSlicer	před 4 years
	How to set consistent printed layers In forum PrusaSlicer	před 4 years
	I went deeper and found that GCode (attached) produced by Pr... In forum Hardware, firmware and software help	před 4 years
	Ok, but when at the end you have tall ears or horns of anima... In forum Hardware, firmware and software help	před 4 years
	Could not print flawlessly a simple 4x4x36 mm cylinder In forum Hardware, firmware and software help	před 4 years
	I contacted the Prusa support and they are sending me two li... In forum Hardware, firmware and software help	před 4 years

Stránka 5 / 6 Předchozí Další

Fórum Statistiky

565 Fóra

63.9 K Témata

447.6 K Příspěvky

23 Online

69.5 K Uživatelé

Poslední Příspěvek: XL mit zwei Köpfen - Mehrfarbdruck in einem Layer Nový Uživatel: SilenceDIY Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed