PrusaTester2020 – Aktywność

Notifications

Clear all

PrusaTester2020

Grupa: Zarejestrowany

Dołączył: 2020/08/31

Estimable Member

	It looked like before the nozzle the filament was held or re... In forum PrusaSlicer	4 years temu
	Hi! Finally managed to completely fix the problem by putting... In forum PrusaSlicer	4 years temu
	Investigation continues. This is a picture from my last prin... In forum PrusaSlicer	4 years temu
	Did all that. Prove me I am wrong but if X and/or Y axis wer... In forum PrusaSlicer	4 years temu
	@tim-m30 The temperatures of the nozzle during the "bad" zon... In forum PrusaSlicer	4 years temu
	I adjusted the belt tension just before the frog print. They... In forum PrusaSlicer	4 years temu
	Sorry but the problem appeared today. It seemed it's not onl... In forum PrusaSlicer	4 years temu
	FIXED: The solution for this strange problem is in this post... In forum Hardware, firmware and software help	4 years temu
	@tim-m30 I tried with 2mm. wall and it was exactly 2mm (chec... In forum PrusaSlicer	4 years temu
	Hi! I think I managed to find what causes all my problems. O... In forum PrusaSlicer	4 years temu
	Yes, I also think that the nozzle with the fillament is pres... In forum PrusaSlicer	4 years temu
	I tried printing using this recommended settings:- lower ret... In forum PrusaSlicer	4 years temu
	Would you send me your config or it's confidential? In forum PrusaSlicer	4 years temu
	Here is the PrusaSlicer 3MK file attached. Attachment remo... In forum Hardware, firmware and software help	4 years temu
	Here is the PrusaSlicer 3MK file attached. Attachment remo... In forum PrusaSlicer	4 years temu
	How to set consistent printed layers In forum PrusaSlicer	4 years temu
	I went deeper and found that GCode (attached) produced by Pr... In forum Hardware, firmware and software help	4 years temu
	Ok, but when at the end you have tall ears or horns of anima... In forum Hardware, firmware and software help	4 years temu
	Could not print flawlessly a simple 4x4x36 mm cylinder In forum Hardware, firmware and software help	4 years temu
	I contacted the Prusa support and they are sending me two li... In forum Hardware, firmware and software help	4 years temu

Strona 5 / 6 Wstecz Następny

Statystyki Forum

565 Fora

63.9 K Tematy

447.6 K Posty

22 Online

69.5 K Członkowie

Ostatni Post: How do I align Parts? Najnowszy użytkownik:: SilenceDIY Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte