Benachrichtigungen
Alles löschen
PrusaTester2020
PrusaTester2020
Gruppe: Registriert
Beigetreten: 2020/08/31
Estimable Member
4
It looked like before the nozzle the filament was held or re...

Im Forum PrusaSlicer

Vor 4 years
Hi! Finally managed to completely fix the problem by putting...

Im Forum PrusaSlicer

Vor 4 years
Investigation continues. This is a picture from my last prin...

Im Forum PrusaSlicer

Vor 4 years
Did all that. Prove me I am wrong but if X and/or Y axis wer...

Im Forum PrusaSlicer

Vor 4 years
@tim-m30 The temperatures of the nozzle during the "bad" zon...

Im Forum PrusaSlicer

Vor 4 years
I adjusted the belt tension just before the frog print. They...

Im Forum PrusaSlicer

Vor 4 years
Sorry but the problem appeared today. It seemed it's not onl...

Im Forum PrusaSlicer

Vor 4 years
FIXED: The solution for this strange problem is in this post...

Im Forum Hardware, firmware and software help

Vor 4 years
@tim-m30 I tried with 2mm. wall and it was exactly 2mm (chec...

Im Forum PrusaSlicer

Vor 4 years
Hi! I think I managed to find what causes all my problems. O...

Im Forum PrusaSlicer

Vor 4 years
Yes, I also think that the nozzle with the fillament is pres...

Im Forum PrusaSlicer

Vor 4 years
I tried printing using this recommended settings:- lower ret...

Im Forum PrusaSlicer

Vor 4 years
Would you send me your config or it's confidential?

Im Forum PrusaSlicer

Vor 4 years
Here is the PrusaSlicer 3MK file attached. Attachment remo...

Im Forum Hardware, firmware and software help

Vor 4 years
Here is the PrusaSlicer 3MK file attached. Attachment remo...

Im Forum PrusaSlicer

Vor 4 years
How to set consistent printed layers

Im Forum PrusaSlicer

Vor 4 years
I went deeper and found that GCode (attached) produced by Pr...

Im Forum Hardware, firmware and software help

Vor 4 years
Ok, but when at the end you have tall ears or horns of anima...

Im Forum Hardware, firmware and software help

Vor 4 years
Could not print flawlessly a simple 4x4x36 mm cylinder

Im Forum Hardware, firmware and software help

Vor 4 years
I contacted the Prusa support and they are sending me two li...

Im Forum Hardware, firmware and software help

Vor 4 years
Seite 5 / 6
Teilen: