Notifications
Clear all
PrusaTester2020
Skupina: Registrovaný
Přidal se: 2020/08/31
Estimable Member
4
|
A strange sound coming from X-axis - linear bearings?!? In forum Hardware, firmware and software help |
před 4 years | |
|
I tried Print Settings->Layers and perimeters->Qualit... In forum PrusaSlicer |
před 4 years | |
|
It was set during the print. Should I un-check it? In forum PrusaSlicer |
před 4 years | |
|
How to avoid bumps that are produced by stuck/glued strings ... In forum PrusaSlicer |
před 4 years | |
| Newbie question: How to avoid 3D print artifacts? | před 4 years | |
| Just received a written info from PRUSA support that "Regard... | před 4 years | |
| I did a few tests: I printed a single layer 30x30 mm. square... | před 4 years | |
| I asked the moderator to fix it and did it by adding a media... | před 4 years | |
| Hum sound when 3D printing ovals/circles | před 4 years | |
| This pre-heating "start gcode" you execute it before each pr... | před 4 years | |
| I said WOW in the chat and asked again a few times, but the ... | před 4 years | |
| Just had an online chat with PRUSA support about the same is... | před 4 years |
Stránka 6 / 6
Předchozí