Prusa3D Forum

Notifiche

Cancella tutti

Potter

Gruppo: Registrato

Registrato: 2022/10/02

Active Member

	The unplugging and plugging back in the motor cables, and th... Nel forum Hardware, firmware and software help	3 years fa
	So, I turned my printer on today, and now the mmu is respond... Nel forum Hardware, firmware and software help	3 years fa
	So I just recently had the all lights flashing and constant ... Nel forum Hardware, firmware and software help	3 years fa
	Constant Red & green flashing lights Nel forum How do I print this? (Printing help)	3 years fa
	I bumped the nozzle temp up 7 degrees and so far it’s going ... Nel forum How do I print this? (Printing help)	3 years fa
	So, after I took my extruder apart and found a little piece ... Nel forum How do I print this? (Printing help)	3 years fa
	Here is a failed print, I have about 10 of these. I tried us... Nel forum How do I print this? (Printing help)	3 years fa
	So I have finally caught it in action and it seems that the ... Nel forum How do I print this? (Printing help)	3 years fa
	Tower_top_with_bells_no_rails Here is the .3mf file. Nel forum How do I print this? (Printing help)	3 years fa
	Problems with a particular file Nel forum How do I print this? (Printing help)	3 years fa

Statistiche Forum

585 Forum

68.2 K Discussioni

477.9 K Post

10 Online

75.9 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso