Prusa3D Forum

Notifications

Clear all

Potter

Groupe: Enregistré

A(ont) rejoint: 2022/10/02

Active Member

	The unplugging and plugging back in the motor cables, and th... Dans le forum Hardware, firmware and software help	il y a 3 years
	So, I turned my printer on today, and now the mmu is respond... Dans le forum Hardware, firmware and software help	il y a 3 years
	So I just recently had the all lights flashing and constant ... Dans le forum Hardware, firmware and software help	il y a 3 years
	Constant Red & green flashing lights Dans le forum How do I print this? (Printing help)	il y a 3 years
	I bumped the nozzle temp up 7 degrees and so far it’s going ... Dans le forum How do I print this? (Printing help)	il y a 3 years
	So, after I took my extruder apart and found a little piece ... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Here is a failed print, I have about 10 of these. I tried us... Dans le forum How do I print this? (Printing help)	il y a 3 years
	So I have finally caught it in action and it seems that the ... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Tower_top_with_bells_no_rails Here is the .3mf file. Dans le forum How do I print this? (Printing help)	il y a 3 years
	Problems with a particular file Dans le forum How do I print this? (Printing help)	il y a 3 years

Statistiques du forum

585 Forums

68.2 K Sujets

477.9 K Messages

10 En-ligne

75.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé