Prusa3D Forum

Notifications

Clear all

MPJ

Group: Registered

Joined: 2017/04/12

Active Member

	One way to adjust this is to loosen the black top nut on the... In forum Prusa i3 kit (Archive)	7 years ago
	You might be past this solution, but when mine was blocked i... In forum Prusa i3 kit (Archive)	8 years ago
	I used the provided gcode and all I did was turn the tempera... In forum Awesome prints (Hall Of Fame)	8 years ago
	I think bottom side turned out very good, don't see that sam... In forum Awesome prints (Hall Of Fame)	8 years ago
	Fixed post above with image. Worked when I used preview, but... In forum Awesome prints (Hall Of Fame)	8 years ago
	Here is my attempt, and by that I mean using the provided gc... In forum Awesome prints (Hall Of Fame)	8 years ago
	Thanks for the camera holder. I printed the spool holder and... In forum Improvements (Archive)	8 years ago
	Great job, simple and effective...on a side note, where did ... In forum Improvements (Archive)	8 years ago
	Not trying to jump in on this thread, but you were asking ab... In forum Prusa i3 kit (Archive)	8 years ago
	I have the same issue using pronterface. I will set the new ... In forum Prusa i3 kit (Archive)	8 years ago
	Are you sure the left side rod is pushed into the slot? The ... In forum Prusa i3 kit (Archive)	8 years ago
	Going to assume this is new. I had same issue and was also a... In forum Prusa i3 kit (Archive)	8 years ago
	Extruder Fan Wiring Error In forum Prusa i3 kit (Archive)	8 years ago

Forum Statistics

565 Forums

63.8 K Topics

447.3 K Posts

20 Online

69.3 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed