|
Weird issue with PETG In forum Hardware, firmware and software help |
před 2 years |
|
@margaret-m Hopefully this allows me to attach. I used tinke... In forum Coronavirus (COVID-19) |
před 5 years |
|
@chuck-k Is there any issue with the rigidity of the materia... In forum Coronavirus (COVID-19) |
před 5 years |
|
I made this in tinkercad with the prusa provided specs. Appa... In forum Coronavirus (COVID-19) |
před 5 years |
|
Using a Cricut for the transparencies In forum Coronavirus (COVID-19) |
před 5 years |
|
Using a Cricut for the transparencies In forum Coronavirus (COVID-19) |
před 5 years |
|
Thanks I had a feeling that it was still good (and prints ha... In forum Assembly and first prints troubleshooting |
před 6 years |
|
Finally got my 2.5 upgrade, bed level question In forum Assembly and first prints troubleshooting |
před 6 years |
|
It is in the printer tab, under gcode flavor. That being sai... In forum Assembly and first prints troubleshooting |
před 7 years |
|
Marlin is the best one to use; it gives much more accurate t... In forum General discussion, announcements and releases |
před 7 years |
|
RepRap or Marlin for gcode flavour? In forum General discussion, announcements and releases |
před 7 years |
|
Thanks for checking Mike,
I'm far from an expert when it co... In forum Assembly and first prints troubleshooting |
před 7 years |
|
note- i also posted this in jeffjordans thread, i tried to d... In forum Assembly and first prints troubleshooting |
před 7 years |
|
I'm having a strange issue.
Well, I think I found it. The... In forum Assembly and first prints troubleshooting |
před 7 years |
|
Strange issue after recalibrating In forum Assembly and first prints troubleshooting |
před 7 years |
|
I'm having a strange issue. If I print the v6.1 gcode downlo... In forum Assembly and first prints troubleshooting |
před 7 years |
|
Ive been thinking of updating to this holder. Im currently u... In forum Others (Archive) |
před 7 years |
|
I think all is well. apparently there was another extended d... In forum Others (Archive) |
před 7 years |
|
If you haven't ordered your 2.5 upgrade for your Mk2/S yet, ... In forum Others (Archive) |
před 7 years |
|
thanks for the response,
I ran a full calibration and live-... In forum Others (Archive) |
před 7 years |
