Prusa3D Forum

Notifications

Clear all

mattberns

Grupa: Zarejestrowany

Dołączył: 2021/12/25

Active Member

	Hi, sorry to be the necromancer and raise this thread from t... In forum Hardware, firmware and software help	2 years temu
	Thank you fuchsr, adjusting SPINDA with zip tie method like ... In forum General discussion, announcements and releases	3 years temu
	Is it normal for Live Adjust Z to be set at -1.977 to have g... In forum General discussion, announcements and releases	3 years temu
	Just fixed it. The XZ axis was attached too far to one of th... In forum Hardware, firmware and software help	3 years temu
	Prusa Mini Setup Wizard not passing on axis tests In forum Hardware, firmware and software help	3 years temu

Statystyki Forum

566 Fora

63.2 K Tematy

444.3 K Posty

19 Online

68.1 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte