Notifications
Clear all
mattberns
Groupe: Enregistré
A(ont) rejoint: 2021/12/25
Active Member
1
|
Hi, sorry to be the necromancer and raise this thread from t... Dans le forum Hardware, firmware and software help |
il y a 2 years | |
|
Thank you fuchsr, adjusting SPINDA with zip tie method like ... Dans le forum General discussion, announcements and releases |
il y a 3 years | |
|
Is it normal for Live Adjust Z to be set at -1.977 to have g... Dans le forum General discussion, announcements and releases |
il y a 3 years | |
|
Just fixed it. The XZ axis was attached too far to one of th... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
Prusa Mini Setup Wizard not passing on axis tests Dans le forum Hardware, firmware and software help |
il y a 3 years |