Prusa3D Forum

Notifications

Clear all

mattberns

Skupina: Registrovaný

Přidal se: 2021/12/25

Active Member

	Hi, sorry to be the necromancer and raise this thread from t... In forum Hardware, firmware and software help	před 2 years
	Thank you fuchsr, adjusting SPINDA with zip tie method like ... In forum General discussion, announcements and releases	před 3 years
	Is it normal for Live Adjust Z to be set at -1.977 to have g... In forum General discussion, announcements and releases	před 3 years
	Just fixed it. The XZ axis was attached too far to one of th... In forum Hardware, firmware and software help	před 3 years
	Prusa Mini Setup Wizard not passing on axis tests In forum Hardware, firmware and software help	před 3 years

Fórum Statistiky

566 Fóra

63.2 K Témata

444.2 K Příspěvky

20 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed