Prusa3D Forum

Notifiche

Cancella tutti

mattberns

Gruppo: Registrato

Registrato: 2021/12/25

Active Member

	Hi, sorry to be the necromancer and raise this thread from t... Nel forum Hardware, firmware and software help	2 years fa
	Thank you fuchsr, adjusting SPINDA with zip tie method like ... Nel forum General discussion, announcements and releases	3 years fa
	Is it normal for Live Adjust Z to be set at -1.977 to have g... Nel forum General discussion, announcements and releases	3 years fa
	Just fixed it. The XZ axis was attached too far to one of th... Nel forum Hardware, firmware and software help	3 years fa
	Prusa Mini Setup Wizard not passing on axis tests Nel forum Hardware, firmware and software help	3 years fa

Statistiche Forum

566 Forum

63.2 K Discussioni

444.3 K Post

22 Online

68.1 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso