Polski
Fora
Członkowie
lysynski
Aktywność
 
Notifications
Clear all
lysynski
lysynski
Grupa: Zarejestrowany
Dołączył: 2024/11/01
Active Member
1
Profil Aktywność
I never had this error until the latest firmware update (6.4...

In forum Hardware, firmware and software help

 4 hours temu
Bad Layer, looks over-extruded in both x & y-axis

In forum Hardware, firmware and software help

 5 months temu
ANYCUBIC Photon Mono 4 Ultra profile for PrusaSlicer

In forum PrusaSlicer

 10 months temu
Thanks for your help.

In forum How do I print this? (Printing help)

 12 months temu
I forgot to mention; the problem happens when I print at 0....

In forum How do I print this? (Printing help)

 12 months temu
I did the cleaning and the nextruder was clean but I did fin...

In forum How do I print this? (Printing help)

 12 months temu
I have the filament guide... I thought of that too so I chec...

In forum How do I print this? (Printing help)

 12 months temu
Here's photo of previous prints that the layer was completel...

In forum How do I print this? (Printing help)

 12 months temu
I did 6 cold pulls then a test print, the problem is still t...

In forum How do I print this? (Printing help)

 12 months temu
I did the cold pull; 1st print was ok, 2nd print was worse. ...

In forum How do I print this? (Printing help)

 12 months temu
Thanks, I’ll give that a try and let you know how it goes ne...

In forum How do I print this? (Printing help)

 12 months temu
Thanks for the information but it’s about 2-5mm of printing...

In forum How do I print this? (Printing help)

 12 months temu
Single layer failure - no or poor adhesion

In forum How do I print this? (Printing help)

 12 months temu
I've reviewed the article and checked the speeds in PrusaSl...

In forum How do I print this? (Printing help)

 1 year temu
Share: