Deutsch
Foren
Mitglieder
lysynski
Aktivität
 
Benachrichtigungen
Alles löschen
lysynski
lysynski
Gruppe: Registriert
Beigetreten: 2024/11/01
Active Member
1
Profil Aktivität
I never had this error until the latest firmware update (6.4...

Im Forum Hardware, firmware and software help

 Vor 10 hours
Bad Layer, looks over-extruded in both x & y-axis

Im Forum Hardware, firmware and software help

 Vor 5 months
ANYCUBIC Photon Mono 4 Ultra profile for PrusaSlicer

Im Forum PrusaSlicer

 Vor 10 months
Thanks for your help.

Im Forum How do I print this? (Printing help)

 Vor 12 months
I forgot to mention; the problem happens when I print at 0....

Im Forum How do I print this? (Printing help)

 Vor 12 months
I did the cleaning and the nextruder was clean but I did fin...

Im Forum How do I print this? (Printing help)

 Vor 12 months
I have the filament guide... I thought of that too so I chec...

Im Forum How do I print this? (Printing help)

 Vor 12 months
Here's photo of previous prints that the layer was completel...

Im Forum How do I print this? (Printing help)

 Vor 12 months
I did 6 cold pulls then a test print, the problem is still t...

Im Forum How do I print this? (Printing help)

 Vor 12 months
I did the cold pull; 1st print was ok, 2nd print was worse. ...

Im Forum How do I print this? (Printing help)

 Vor 12 months
Thanks, I’ll give that a try and let you know how it goes ne...

Im Forum How do I print this? (Printing help)

 Vor 12 months
Thanks for the information but it’s about 2-5mm of printing...

Im Forum How do I print this? (Printing help)

 Vor 12 months
Single layer failure - no or poor adhesion

Im Forum How do I print this? (Printing help)

 Vor 12 months
I've reviewed the article and checked the speeds in PrusaSl...

Im Forum How do I print this? (Printing help)

 Vor 1 year
Teilen: