Français
Forums
Membres
lysynski
Activité
 
Notifications
Clear all
lysynski
lysynski
Groupe: Enregistré
A(ont) rejoint: 2024/11/01
Active Member
1
Profil Activité
Bad Layer, looks over-extruded in both x & y-axis

Dans le forum Hardware, firmware and software help

 il y a 4 months
ANYCUBIC Photon Mono 4 Ultra profile for PrusaSlicer

Dans le forum PrusaSlicer

 il y a 9 months
Thanks for your help.

Dans le forum How do I print this? (Printing help)

 il y a 10 months
I forgot to mention; the problem happens when I print at 0....

Dans le forum How do I print this? (Printing help)

 il y a 10 months
I did the cleaning and the nextruder was clean but I did fin...

Dans le forum How do I print this? (Printing help)

 il y a 10 months
I have the filament guide... I thought of that too so I chec...

Dans le forum How do I print this? (Printing help)

 il y a 10 months
Here's photo of previous prints that the layer was completel...

Dans le forum How do I print this? (Printing help)

 il y a 10 months
I did 6 cold pulls then a test print, the problem is still t...

Dans le forum How do I print this? (Printing help)

 il y a 10 months
I did the cold pull; 1st print was ok, 2nd print was worse. ...

Dans le forum How do I print this? (Printing help)

 il y a 10 months
Thanks, I’ll give that a try and let you know how it goes ne...

Dans le forum How do I print this? (Printing help)

 il y a 10 months
Thanks for the information but it’s about 2-5mm of printing...

Dans le forum How do I print this? (Printing help)

 il y a 10 months
Single layer failure - no or poor adhesion

Dans le forum How do I print this? (Printing help)

 il y a 10 months
I've reviewed the article and checked the speeds in PrusaSl...

Dans le forum How do I print this? (Printing help)

 il y a 1 year
Partager :