Prusa3D Forum

Notifications

Clear all

lysynski

Skupina: Registrovaný

Přidal se: 2024/11/01

Active Member

	Bad Layer, looks over-extruded in both x & y-axis In forum Hardware, firmware and software help	před 4 months
	ANYCUBIC Photon Mono 4 Ultra profile for PrusaSlicer In forum PrusaSlicer	před 9 months
	Thanks for your help. In forum How do I print this? (Printing help)	před 10 months
	I forgot to mention; the problem happens when I print at 0.... In forum How do I print this? (Printing help)	před 10 months
	I did the cleaning and the nextruder was clean but I did fin... In forum How do I print this? (Printing help)	před 10 months
	I have the filament guide... I thought of that too so I chec... In forum How do I print this? (Printing help)	před 10 months
	Here's photo of previous prints that the layer was completel... In forum How do I print this? (Printing help)	před 10 months
	I did 6 cold pulls then a test print, the problem is still t... In forum How do I print this? (Printing help)	před 10 months
	I did the cold pull; 1st print was ok, 2nd print was worse. ... In forum How do I print this? (Printing help)	před 10 months
	Thanks, I’ll give that a try and let you know how it goes ne... In forum How do I print this? (Printing help)	před 10 months
	Thanks for the information but it’s about 2-5mm of printing... In forum How do I print this? (Printing help)	před 10 months
	Single layer failure - no or poor adhesion In forum How do I print this? (Printing help)	před 10 months
	I've reviewed the article and checked the speeds in PrusaSl... In forum How do I print this? (Printing help)	před 12 months

Fórum Statistiky

595 Fóra

68.8 K Témata

481.5 K Příspěvky

20 Online

77.5 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed