English
Forums
Members
lysynski
Activity
 
Notifications
Clear all
lysynski
lysynski
Group: Registered
Joined: 2024/11/01
Active Member
1
Profile Activity
I never had this error until the latest firmware update (6.4...

In forum Hardware, firmware and software help

 17 hours ago
Bad Layer, looks over-extruded in both x & y-axis

In forum Hardware, firmware and software help

 5 months ago
ANYCUBIC Photon Mono 4 Ultra profile for PrusaSlicer

In forum PrusaSlicer

 10 months ago
Thanks for your help.

In forum How do I print this? (Printing help)

 12 months ago
I forgot to mention; the problem happens when I print at 0....

In forum How do I print this? (Printing help)

 12 months ago
I did the cleaning and the nextruder was clean but I did fin...

In forum How do I print this? (Printing help)

 12 months ago
I have the filament guide... I thought of that too so I chec...

In forum How do I print this? (Printing help)

 12 months ago
Here's photo of previous prints that the layer was completel...

In forum How do I print this? (Printing help)

 12 months ago
I did 6 cold pulls then a test print, the problem is still t...

In forum How do I print this? (Printing help)

 12 months ago
I did the cold pull; 1st print was ok, 2nd print was worse. ...

In forum How do I print this? (Printing help)

 12 months ago
Thanks, I’ll give that a try and let you know how it goes ne...

In forum How do I print this? (Printing help)

 12 months ago
Thanks for the information but it’s about 2-5mm of printing...

In forum How do I print this? (Printing help)

 12 months ago
Single layer failure - no or poor adhesion

In forum How do I print this? (Printing help)

 12 months ago
I've reviewed the article and checked the speeds in PrusaSl...

In forum How do I print this? (Printing help)

 1 year ago
Share: