Prusa3D Forum

Notifiche

Cancella tutti

lysynski

Gruppo: Registrato

Registrato: 2024/11/01

Active Member

	Bad Layer, looks over-extruded in both x & y-axis Nel forum Hardware, firmware and software help	4 months fa
	ANYCUBIC Photon Mono 4 Ultra profile for PrusaSlicer Nel forum PrusaSlicer	9 months fa
	Thanks for your help. Nel forum How do I print this? (Printing help)	10 months fa
	I forgot to mention; the problem happens when I print at 0.... Nel forum How do I print this? (Printing help)	10 months fa
	I did the cleaning and the nextruder was clean but I did fin... Nel forum How do I print this? (Printing help)	10 months fa
	I have the filament guide... I thought of that too so I chec... Nel forum How do I print this? (Printing help)	10 months fa
	Here's photo of previous prints that the layer was completel... Nel forum How do I print this? (Printing help)	10 months fa
	I did 6 cold pulls then a test print, the problem is still t... Nel forum How do I print this? (Printing help)	10 months fa
	I did the cold pull; 1st print was ok, 2nd print was worse. ... Nel forum How do I print this? (Printing help)	10 months fa
	Thanks, I’ll give that a try and let you know how it goes ne... Nel forum How do I print this? (Printing help)	10 months fa
	Thanks for the information but it’s about 2-5mm of printing... Nel forum How do I print this? (Printing help)	10 months fa
	Single layer failure - no or poor adhesion Nel forum How do I print this? (Printing help)	10 months fa
	I've reviewed the article and checked the speeds in PrusaSl... Nel forum How do I print this? (Printing help)	1 year fa

Statistiche Forum

595 Forum

68.9 K Discussioni

482 K Post

13 Online

77.6 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso