Español
Foros
Miembros
lysynski
Actividad
 
Avisos
Vaciar todo
lysynski
lysynski
Grupo: Registrado
Registrado: 2024/11/01
Active Member
1
Perfil Actividad
Bad Layer, looks over-extruded in both x & y-axis

En el foro Hardware, firmware and software help

 hace 2 months
ANYCUBIC Photon Mono 4 Ultra profile for PrusaSlicer

En el foro PrusaSlicer

 hace 7 months
Thanks for your help.

En el foro How do I print this? (Printing help)

 hace 8 months
I forgot to mention; the problem happens when I print at 0....

En el foro How do I print this? (Printing help)

 hace 9 months
I did the cleaning and the nextruder was clean but I did fin...

En el foro How do I print this? (Printing help)

 hace 9 months
I have the filament guide... I thought of that too so I chec...

En el foro How do I print this? (Printing help)

 hace 9 months
Here's photo of previous prints that the layer was completel...

En el foro How do I print this? (Printing help)

 hace 9 months
I did 6 cold pulls then a test print, the problem is still t...

En el foro How do I print this? (Printing help)

 hace 9 months
I did the cold pull; 1st print was ok, 2nd print was worse. ...

En el foro How do I print this? (Printing help)

 hace 9 months
Thanks, I’ll give that a try and let you know how it goes ne...

En el foro How do I print this? (Printing help)

 hace 9 months
Thanks for the information but it’s about 2-5mm of printing...

En el foro How do I print this? (Printing help)

 hace 9 months
Single layer failure - no or poor adhesion

En el foro How do I print this? (Printing help)

 hace 9 months
I've reviewed the article and checked the speeds in PrusaSl...

En el foro How do I print this? (Printing help)

 hace 11 months
Compartir: