Prusa3D Forum

Benachrichtigungen

Alles löschen

lysynski

Gruppe: Registriert

Beigetreten: 2024/11/01

Active Member

	Bad Layer, looks over-extruded in both x & y-axis Im Forum Hardware, firmware and software help	Vor 2 months
	ANYCUBIC Photon Mono 4 Ultra profile for PrusaSlicer Im Forum PrusaSlicer	Vor 7 months
	Thanks for your help. Im Forum How do I print this? (Printing help)	Vor 8 months
	I forgot to mention; the problem happens when I print at 0.... Im Forum How do I print this? (Printing help)	Vor 8 months
	I did the cleaning and the nextruder was clean but I did fin... Im Forum How do I print this? (Printing help)	Vor 9 months
	I have the filament guide... I thought of that too so I chec... Im Forum How do I print this? (Printing help)	Vor 9 months
	Here's photo of previous prints that the layer was completel... Im Forum How do I print this? (Printing help)	Vor 9 months
	I did 6 cold pulls then a test print, the problem is still t... Im Forum How do I print this? (Printing help)	Vor 9 months
	I did the cold pull; 1st print was ok, 2nd print was worse. ... Im Forum How do I print this? (Printing help)	Vor 9 months
	Thanks, I’ll give that a try and let you know how it goes ne... Im Forum How do I print this? (Printing help)	Vor 9 months
	Thanks for the information but it’s about 2-5mm of printing... Im Forum How do I print this? (Printing help)	Vor 9 months
	Single layer failure - no or poor adhesion Im Forum How do I print this? (Printing help)	Vor 9 months
	I've reviewed the article and checked the speeds in PrusaSl... Im Forum How do I print this? (Printing help)	Vor 11 months

Forums-Statistiken

585 Foren

68.2 K Themen

478 K Beiträge

13 Online

76 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen