Prusa3D Forum

Notifications

Clear all

lysynski

Group: Registered

Joined: 2024/11/01

Active Member

	Bad Layer, looks over-extruded in both x & y-axis In forum Hardware, firmware and software help	2 months ago
	ANYCUBIC Photon Mono 4 Ultra profile for PrusaSlicer In forum PrusaSlicer	7 months ago
	Thanks for your help. In forum How do I print this? (Printing help)	8 months ago
	I forgot to mention; the problem happens when I print at 0.... In forum How do I print this? (Printing help)	8 months ago
	I did the cleaning and the nextruder was clean but I did fin... In forum How do I print this? (Printing help)	8 months ago
	I have the filament guide... I thought of that too so I chec... In forum How do I print this? (Printing help)	8 months ago
	Here's photo of previous prints that the layer was completel... In forum How do I print this? (Printing help)	8 months ago
	I did 6 cold pulls then a test print, the problem is still t... In forum How do I print this? (Printing help)	8 months ago
	I did the cold pull; 1st print was ok, 2nd print was worse. ... In forum How do I print this? (Printing help)	8 months ago
	Thanks, I’ll give that a try and let you know how it goes ne... In forum How do I print this? (Printing help)	9 months ago
	Thanks for the information but it’s about 2-5mm of printing... In forum How do I print this? (Printing help)	9 months ago
	Single layer failure - no or poor adhesion In forum How do I print this? (Printing help)	9 months ago
	I've reviewed the article and checked the speeds in PrusaSl... In forum How do I print this? (Printing help)	11 months ago

Forum Statistics

585 Forums

68.2 K Topics

477.9 K Posts

9 Online

75.9 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed