Prusa3D Forum

Notifiche

Cancella tutti

Gruppo: Registrato

Registrato: 2017/03/25

Active Member

	I looked at some PTFE tubing that had a smaller ID. I was co... Nel forum Hardware, firmware and software help	6 years fa
	Would PTFE tubing with a smaller inner diameter improve retr... Nel forum Hardware, firmware and software help	6 years fa
	I’ve been using Cura 3.4 with the MK2s using the setup guide... Nel forum General discussion, announcements and releases	6 years fa
	Comparing Belt Tension Nel forum General discussion, announcements and releases	7 years fa
	In Slic3r, Prusa includes custom gcode in the printer settin... Nel forum General discussion, announcements and releases	7 years fa
	The extrusion multipliers are what I needed to get smooth 10... Nel forum General discussion, announcements and releases	7 years fa
	Under/Overextrusion Due To Change In Layer Height Nel forum General discussion, announcements and releases	7 years fa
	Glad to see official support for Cura. I love it. Nel forum General discussion, announcements and releases	7 years fa

Statistiche Forum

565 Forum

64.5 K Discussioni

451.8 K Post

26 Online

71.1 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso