Prusa3D Forum

Notifications

Clear all

Groupe: Enregistré

A(ont) rejoint: 2017/03/25

Active Member

	I looked at some PTFE tubing that had a smaller ID. I was co... Dans le forum Hardware, firmware and software help	il y a 6 years
	Would PTFE tubing with a smaller inner diameter improve retr... Dans le forum Hardware, firmware and software help	il y a 6 years
	I’ve been using Cura 3.4 with the MK2s using the setup guide... Dans le forum General discussion, announcements and releases	il y a 6 years
	Comparing Belt Tension Dans le forum General discussion, announcements and releases	il y a 6 years
	In Slic3r, Prusa includes custom gcode in the printer settin... Dans le forum General discussion, announcements and releases	il y a 6 years
	The extrusion multipliers are what I needed to get smooth 10... Dans le forum General discussion, announcements and releases	il y a 6 years
	Under/Overextrusion Due To Change In Layer Height Dans le forum General discussion, announcements and releases	il y a 6 years
	Glad to see official support for Cura. I love it. Dans le forum General discussion, announcements and releases	il y a 6 years

Statistiques du forum

559 Forums

63.1 K Sujets

444 K Messages

19 En-ligne

68 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé