Prusa3D Forum

Benachrichtigungen

Alles löschen

Gruppe: Registriert

Beigetreten: 2017/03/25

Active Member

	I looked at some PTFE tubing that had a smaller ID. I was co... Im Forum Hardware, firmware and software help	Vor 6 years
	Would PTFE tubing with a smaller inner diameter improve retr... Im Forum Hardware, firmware and software help	Vor 6 years
	I’ve been using Cura 3.4 with the MK2s using the setup guide... Im Forum General discussion, announcements and releases	Vor 6 years
	Comparing Belt Tension Im Forum General discussion, announcements and releases	Vor 6 years
	In Slic3r, Prusa includes custom gcode in the printer settin... Im Forum General discussion, announcements and releases	Vor 6 years
	The extrusion multipliers are what I needed to get smooth 10... Im Forum General discussion, announcements and releases	Vor 6 years
	Under/Overextrusion Due To Change In Layer Height Im Forum General discussion, announcements and releases	Vor 6 years
	Glad to see official support for Cura. I love it. Im Forum General discussion, announcements and releases	Vor 6 years

Forums-Statistiken

559 Foren

63 K Themen

443.7 K Beiträge

24 Online

67.9 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen