Notifications
Clear all
K
Skupina: Registrovaný
Přidal se: 2017/03/25
Active Member
1
|
I looked at some PTFE tubing that had a smaller ID. I was co... In forum Hardware, firmware and software help |
před 6 years | |
|
Would PTFE tubing with a smaller inner diameter improve retr... In forum Hardware, firmware and software help |
před 6 years | |
| I’ve been using Cura 3.4 with the MK2s using the setup guide... | před 6 years | |
| Comparing Belt Tension | před 6 years | |
| In Slic3r, Prusa includes custom gcode in the printer settin... | před 6 years | |
| The extrusion multipliers are what I needed to get smooth 10... | před 6 years | |
| Under/Overextrusion Due To Change In Layer Height | před 6 years | |
| Glad to see official support for Cura. I love it. | před 6 years |