Avisos
Vaciar todo
K
Grupo: Registrado
Registrado: 2017/03/25
Active Member
1
|
I looked at some PTFE tubing that had a smaller ID. I was co... En el foro Hardware, firmware and software help |
hace 6 years | |
|
Would PTFE tubing with a smaller inner diameter improve retr... En el foro Hardware, firmware and software help |
hace 6 years | |
| I’ve been using Cura 3.4 with the MK2s using the setup guide... | hace 6 years | |
| Comparing Belt Tension | hace 7 years | |
| In Slic3r, Prusa includes custom gcode in the printer settin... | hace 7 years | |
| The extrusion multipliers are what I needed to get smooth 10... | hace 7 years | |
| Under/Overextrusion Due To Change In Layer Height | hace 7 years | |
| Glad to see official support for Cura. I love it. | hace 7 years |