Prusa3D Forum

Notifications

Clear all

John McCauley

Grupa: Zarejestrowany

Dołączył: 2022/08/17

Eminent Member

	Thanks. I actually turned off the fan. Still did not get hot... In forum PrusaSlicer	3 months temu
	That is my fall back. Right now it is not an issue. Point be... In forum General discussion, announcements and releases	4 months temu
	Latest firmware 6.0.4 does seem to work well with high temp ... In forum General discussion, announcements and releases	4 months temu
	Still need to contact Prusa. Looks like the Prusa XL just is... In forum How do I print this? (Printing help)	6 months temu
	Chamber temperature not followed on XL with enclosure In forum PrusaSlicer	6 months temu
	Not sure how I missed it there is a Chamber temperature sett... In forum How do I print this? (Printing help)	6 months temu
	See my thread on printing ABS-CF. Also need high temperature... In forum How do I print this? (Printing help)	6 months temu
	I turned off the fan on the printhead. So initially the temp... In forum How do I print this? (Printing help)	6 months temu
	For small prints there are no issues. The print that I had s... In forum How do I print this? (Printing help)	6 months temu
	Printing ABS-CF, needing 50c in the enclosure In forum How do I print this? (Printing help)	6 months temu
	Increasing the temperature did fix it for the test print but... In forum Assembly and first prints troubleshooting	8 months temu
	The first layer was sticking correctly. So I increased the t... In forum Assembly and first prints troubleshooting	8 months temu
	Bumpy surface In forum Assembly and first prints troubleshooting	8 months temu
	Print issue with object alignment In forum Hardware, firmware and software help	9 months temu
	I think I have found a way to do it. Always save to file and... In forum General discussion, announcements and releases	12 months temu
	Thanks, that is needed. I think the solution is to add the f... In forum General discussion, announcements and releases	12 months temu
	How do I keep the tool assignments, when updating model? In forum General discussion, announcements and releases	12 months temu
	Chatted with support. Tried again and it worked! In forum Assembly and first prints troubleshooting	1 year temu
	First print from PRUSA slicer failed In forum Assembly and first prints troubleshooting	1 year temu
	So far so good In forum Assembly and first prints troubleshooting	1 year temu

Strona 1 / 2 Następny

Statystyki Forum

565 Fora

63.6 K Tematy

446.3 K Posty

20 Online

69 K Członkowie

Ostatni Post: MK4S/MMU3 Print Issues Najnowszy użytkownik:: twh344 Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte